Quantity In Stock: 5+
1990–1995 Toyota 4Runner Adjustable Trailing Arms | 2nd Gen | Stock to 6" Lift
Factory trailing arms on the 2nd gen 4Runner are fixed-length — fine at stock height, but add lift and pinion angle drops, driveline vibration increases, and U-joint wear begins. The Apoc Industries Adjustable Trailing Arms restore proper rear suspension geometry at any lift height from stock to 6", giving your 2nd gen the adjustability it was never built with from the factory.
Fits 1990–1995 Toyota 4Runner (2nd Gen, 4WD). Includes all 4 arms. Built in the USA.
Features
- Full Adjustability: Stock to 6" lift — set precisely to your build height.
- Pinion Angle Correction: Restores proper driveline geometry to eliminate vibration and extend U-joint life.
- Axle Re-Centering: Corrects rear axle position after lift for proper geometry.
- DOM Tubing with Bushing Ends: Heavy-wall DOM tubing for rigidity and strength.
- Polyurethane Bushings with Grease Fittings: Long-life, serviceable bushings.
- Uses Factory Hardware: Direct bolt-in, no modifications required.
- USA-Made: Built by Apoc Industries.
What's Included
- 2x Upper trailing arms
- 2x Lower trailing arms
- Polyurethane bushings with grease fittings pre-installed
- Installation instructions with arm length settings by lift height
- Optional: metric 10.9 hardware kit available at checkout
Installation
- Est. Install Time: 3–4 hours
- Tools Required: Basic hand tools, jack, jack stands
- Set arm length to match lift height before tightening jam nuts
- Verify lift height with your lift kit manufacturer if unsure
- Alignment recommended after installation
Fitment
- 1990–1995 Toyota 4Runner (2nd Gen, 4WD)
- Lift Range: Stock to 6"
Complete Your 2nd Gen 4Runner Build
- 1996–2002 4Runner Trailing Arms (3rd Gen) — next generation version
- 1990–1995 4Runner Hood Ditch Light Mounts — complete your 2nd gen build
- Apoc Build Blog — Toyota suspension install guides